Stair Company Near Hamptons – There’s More Than What You Know Already On This Page..

In case you are buying a stair with balusters in a contrasting material, like painted balusters on an oak stair, questions will probably arise with regards to the finishing of the stair. “Should my painter finish the balusters separately from the stair, then have the balusters installed once the stair is completed?

Below are a few points to consider with Wood Stair Company: Your painter will normally choose painting the balusters before installation. This allows them to be sprayed instead of brushed and eliminates lots of “cut-in” work.

Painting balusters separately does mean that this stair installers will need to revisit the site, remove the railings and install the balusters. You will have charge with this “second trip” towards the jobsite. You will need to be sure you schedule this “second trip” in coordination using the completing the finish.

Leaving your balusters out for painting implies that they will probably be lost or stolen during this time. You may be accountable for balusters left in the jobsite. After the painted balusters are finally installed, you will see additional “touch-up finishing required at the rail joints. Holes will need to be filled and stain and finish re-requested the ultimate finish.

Plan installing of your hardwood stair for after your drywall continues to be taped, sanded, and primed. The drywall process can affect the stair. Drywall mud and paint overspray will make the stair finishing process very difficult and might make desired results impossible to accomplish.

Most hardwoods are an open grain wood and once dirt gets a part of open grain it is quite hard to remove, even with sanding. This will have a negative effect on the appearance and texture from the finish. Care also must be used to protect the stair from dirt and mud.

Never Cover Hardwood Stairs With Plastic. Plastic fails to allow airflow, trapping moisture underneath and resulting in the wood to expand and contract. This expansion and contraction causes the wood joints to open up and may cause the wood to crack.

The environmental conditions inside the house are important to the caliber of the stair. Hardwood lumber has become dried by way of a very controlled process to an industry standard moisture content of 6 – 8%. This matches the moisture content vcbxbf the typical home and allows the wood to stay stable under normal conditions.

In cold climates, when a home is heated to a high temperature during winter, air could become very dry, causing the wood to shrink. This shrinkage will make cracks visible in the wood and joints may begin to start up. Subjecting a stair to high levels of heat is much like putting it inside an oven and definately will accelerate the deterioration of the stair.

All hardwoods should be sealed on all sides to retard movement and protect from contact with elements and damage. It is suggested to seal wood immediately.

Leave a Reply

Your email address will not be published. Required fields are marked *